cneke
 home<< product information
35 KV grade epoxy dry-type transformer
The voltage is 35 KV, the capacity of the distribution transformer SC (H) B 10 is 100 -3150 KVA, and that of the power transformer SC (H) 10 is 800-25000 KVA. The new generation H Grade insulation transformer is developed on the basis of the advanced technology; both of the design and the production process are fully in accordance with the standard of IEC60076, GB6450 and GB/T10228. And therefore this type of transformer is widely used in the places such as electric plants, power plants, industrial and mining ...
SCB series dry-type power transformer
Safety, flame-retardant, free of pollution and can go deep into the load center. Free of maintenance, easy installation and low general running cost. Good ability of humidity resistance and it can run normally under 100% humidity, and can go to the running without pre-drying after operation. It has the features of Low loss, low partial discharge, low noise, and good ability of ...
dry type power transformer
This type of transformer can go deep into the load center, and has the features of flame-retardant, explosion-proof, free from pollution. It applies the epoxy casting mode and therefore has high mechanical property, and strong withstand of short-circuit, running safely, low loss, efficient power-saving. The loss is 40% lower than that of the three-phase dry-type power transformer which has the same capacity, low noise, small size and easy ...